Update: (Sept 26) All repeaters on North-West Zone (VE9SQN, VE9RCV, VE9GFL and VE9STL) are now fully CTCSS enabled (151.4 Hz PL tone on TX and RX)
Update: (Sept 27) All repeaters on West Zone (VE9KMT, VE9IRG and VE1PD) are now fully CTCSS enabled (151.4 Hz PL tone on TX and RX)
For more information about the phase-in of CTCSS and other changes to the IRG system, visit the IRG revamp page.
The VE9SID repeater in St-Isidore / Tracadie area (146.700) and VE9VDR Seven Mile Ridge / Campbellton (147.390) were both upgraded on August 14 to be fully CTCSS enabled on both TX and RX. You will need to enable CTCSS (PL tone) of 151.4 Hz to operate those repeaters when transmitting. Setting the CTCSS on the receive of your radio at your end is optional, but can help eliminate stray signals on the same frequency as your local repeater.
Updated July 27: VE9NRV repeater (147.030) is back on-air, hardware has been replaced following a lightning strike at the site last week. The Stanley and Grand Lake repeaters are back in normal operation.
The VE9GMI (146.955 -) is now in operation on Campobello Island, with CTCSS set to 151.4 Hz. The Bunker Hill location replaces the former Grand Manan Island site, which was decomissioned. As of June 20, the repeater is "stand alone" but will be linkable in the near future, as part of the South West Zone.
There are a couple of quirks still to work out and users may notice:
The new Grand Lake repeater has been added to the IRG linking system. VE9GLA has a frequency of 145.190 (minus offset). The repeater is located on Hardwood Ridge, and is now included in the Stanley Zone in the linking system. Users can use the regular codes to link to or from Stanley Zone for contact within Grand Lake area.
The repeater was installed in December 2019 and was operating with good coverage as a stand-alone repeater. With its hard-link to Stanley, VE9GLA adds a wider area coverage to central New Brunswick.
How to make your mask fit better using three rubber bands.